All the brackets necessary for the Super Duty front Dana 60 axle
swap into a Jeep JK Wrangler ('07-'18), JL Wrangler (2018+) or JT Gladiator (2020+)
Stronger Design, Lighter Weight, Easier Install
-Single Adjustable Truss Upper Link Mount for use with 2.63" wide joints in a 3-link style suspension. DOES NOT include DIFFERENTIAL TOP CAP
-Daystar Bushings in Factory location. Includes DIFFERENTIAL TOP CAP
-RockJock Johnny Joints in Factory Location. Includes DIFFERENTIAL TOP CAP
The Front Dana 60 that works with this kit is from Ford Superduty F-250 and F-350 trucks from model years 2005+ (coil spring). This truss is not intended for older axles due to different differential offsets.
Trimming of the factory differential casting will be necessary (see instructions). Other fabrication and modifications may be needed due to variances in lift kits and other factors.
Due to the larger casting on the 60 differential, the Lower Control Arm (LCA) brackets are wider than factory location (41.5" Center to Center). Modifications to your Lower Control Arms will likely be necessary. If you have adjustable arms with flexible style joints (heims, Johnny Joints, etc), modifications may not be necessary. Upper Control Arm (UCA) brackets are also slightly higher than factory so adjustable arms may be necessary. The shock mounts are also slightly higher (1.25") than stock to clear the lower control arms.
NOTE: This kit does not include any parts for ABS sensors. It is only a bracket kit. Hooking up and configuring these sensors is the responsibility of the end user.
60 axles DO NOT MATCH the factory JK 5 lug wheel bolt pattern. New wheels will need to be purchased to do this swap. Brake and Steering components NOT INCLUDED in this product, but will be available soon.
This will likely require bumpstop extensions and a new trackbar since the steering is different on this axle from factory axle. The trackbar bracket is higher than stock location to allow proper steering geometry.
** In rare and extreme cases, the truss may come into contact with oil pan. Prior to operating the vehicle, remove the coil springs, cycle the suspension including full compression of both sides simultaneously and add bump stop extensions to prevent damage to oil pan.